Cyron-lighting HT1502W2 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Cyron-lighting HT1502W2. Cyron Lighting HT1502W2 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
21029 Itasca st., CHATSWORTH, CALIFORNIA 91311 USA
www.CYRON.com
Multicolor LED Lighting System
Media Highlighter
HTP1502W2/HTP2402W2
Thank you for purchasing CYRON Multicolor LED Lighting System. This system will bring the latest lighting technology to
your home theatre, home décor, cabinets, and many other areas you choose. Installation of the system is simple and it can be done
by anyone with little or no electrical experience. Nonetheless, some custom installations may require professional help. Please
contact CYRON Technical Support at 818-772-1900 ext.106 for advice.
General Cautions
To reduce the risk of fire, electric shock, or injury:
Route and secure cords so that they will not be pinched or damaged
To further secure the wires, use only insulated staples or plastic ties
Not intended for recessed installations
Not intended for surface installation inside built-in furnishings
Do not install the entire system in closed compartments smaller than 4 cubic feet (26”x30”x10”)
To comply with National Electrical Code (NEC) and to prevent fire danger, run the cords where they are accessible for
examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.
Contents
Please locate all system components. If any of the components are missing or damaged contact CYRON before
proceeding with installation.
1 x Controller / Hub
2 x Light bars
1 x Power supply
4 x Mounting brackets
Tapes, Hardware, Wipes
Installations
1. LIGHTBAR LOCATIONS NOTE: Depending on the application, as few as one or as
many as six light bars may be used. There are many intended uses and methods of light
placement. In most of the cases, the objective is to place the light bar so it is not
directly visible, and its projected light is only seen. This is particularly important if
combined colors such as white are being produced. Feel free to experiment with light
placement and direction of light projection. There may be more than one good
location.
Television Backlighting: The best location for television installations is normally
behind the TV, about 1 to 4 inches from the outer edges (left and right in most cases).
Also, vertically center the bars. See TV backlighting diagram. The exact location may
vary depending on the make and model of the TV.
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1

21029 Itasca st., CHATSWORTH, CALIFORNIA 91311 USA www.CYRON.com Multicolor LED Lighting System Media Highlighter HTP1502W2/HTP2402W2 Than

Page 2 - Operations

Cabinets, Shelving, Furniture: Typical locations are: Top or bottom of the cabinets, behind furniture trimmings, on the shelves, and behind glass cove

Page 3 - Technical Support

available in STROBE, STEP, FADE, and COLOR modes. Brightness can also be adjusted in 5 steps. This can only be done when displaying solid colors. 2.

Page 4 - Specifications

21029 Itasca st Chatsworth, CA 91311 USA Further warranty inquiries: [email protected] Specifications Supply voltage range 100-240VAC, 50/60Hz DC

Commentaires sur ces manuels

Pas de commentaire